| The
primary difference between these two units are the MotorHead 20 handles
cameras up to 20 lbs while Motorhead 30 cradles cameras to 30 lbs.
The MotorHead is
a precision, remotely controlled 2 axis pan & tilt unit for video or
film cameras. It mounts over or under the end of a JonyJib or most other jib
arms. It can also be bolted to a stationary mount. It has features found on
more expensive units but with a very attractive price. The MotorHead will
pan and tilt your camera up to 360 degrees on either axis, smoothly and
accurately by a proportional joystick, giving you full flexibility and
control of your dramatic shots.
The MotorHead can
operate on 12 to 24 volts DC and is equipped with an 'industry standard' 4
pin XLR power connector. The highest quality Maxon coreless motors are used
on the MotorHead 20 & 30.
The MotorHead is
fitted with a 20 foot control cable so that it fits any JonyJib without the
need for extension cables. The new digital control of the MotorHead includes
Linear or Logarithmic joystick capability with knobs to adjust your
preference of deadspot and speed control.
- Linear Joystick
- Each degree of movement reflects and equal amount of speed increase.
- Logarithmic
Joystick - In the first half of the joystick movement, each degree reflects
smaller increases in speed. Second half of joystick movement increases
faster to catch up to full power. This makes slow speed more controllable
yet keeps top speeds available if necessary.
- Deadspot - Opens
the center of the joystick where no movement of the motors occurs. This way
you can set it to your abilities and insure no crossover to the other axis
when not wanted.
- Speed Control -
Limits top speed and spreads the new speed over the full movement of the
joystick. Creating more accuracy where needed.
Order your MotorHead today to compliment your
JonyJib!
|
